Forums

Welcome to the ModTalk forums, the online community where fellow RVers share the modifications they make to their RVs. If this is your first visit, be sure to check out the forum FAQ. It’s full of information to help you get started discussing your mods. In order to post, you will need to register. This helps us to ensure good quality discussion among fellow RVers. It just takes a minute and the rewards are endless…really!
You must be logged in to post Login Register

Search 
Search Forums:


 




Home Forums ModMyRV Community Chatter Power Charger/Inverter swap out

Power Charger/Inverter swap out
Page: 1
UserPost

2:39 pm
November 22, 2010


HarleyFXRC

Mod Newbie

HarleyFXRC

posts 1
1

I have a Parallax Power Components converter charger series 900, model 950 rated at 50 amps currently installed in the coach. It is connected to an RV Custom Products circuit board, model (?) TCM1 4203 rev 6. It has a 50 amp non switched circuit that I beleve is for battery charging. I want to upgrade it wih a Inteli-Power series 9200, model PD9280 dated at 80 amps. My question?? Do I need to replace the RV Custom circuit board or just swap them out?? I have photos of the circuit board if needed.

3:20 pm
November 22, 2010


ModMyRV

Admin

Gardnerville, NV

posts 302
2

Welcome to the forums! You should be able to do a direct swap out. I had a Parallax load center very similar to your model and I swapped out the charger section with an Intelli-Power 9260. This was a couple of years ago but I don't think the Parallax or the Intelli-Power have change significantly since then.

Post an image just in case though!
Page: 1
Topic RSS 

About the ModMyRV forum

Currently Online:

9 Guests

Maximum Online: 66

Forums:

Groups: 2

Forums: 13

Topics: 603

Posts: 1388

Members:

There are 2203 members

There are 1 guests


ModMyRV has made 302 posts

Top Posters:

Bob Vaughn - 208

Mark Corgan - 81

ROBERTSUNRUS - 67

Ozz - 40

Denise in Ark - 18

Administrator: ModMyRV | Moderators: ModMyRV, Mark Corgan